ID #1014

I read in the manual that the standby and mute modes can be commanded with the remote, not the choice of the output, which has to be done manually. Is it possible to leave the standby or mute mode with the remote and if so, what output becomes then active? Or can the standby/mute mode only be left manually?

The Eklipse’s remote control handles the functions: ‘input select’, ‘volume’, ‘stand by’ and ‘mute’. The outputs must be selected manually. The XLR outputs are permanently active, while the signal out of the two pairs of RCA outputs is selectable between ‘pair 1’, ‘pair 2’ or ‘both pairs’.

Last update: 2004-02-24 14:28
Author: Helmut
Revision: 1.0

Print this record Print this record
Send to a friend Send to a friend
Show this as PDF file Show this as PDF file
Export as XML-File Export as XML-File

Please rate this entry:

Average rating: 5 out of 5 (3 Votes )

completely useless 1 2 3 4 5 most valuable

You can comment on this entry

Comment of JimmiNil (2017-11-28 23:57:59):