ID #1046

setup routine for new multi functional remote control

AudioValve`s -

multi function remote control - setup

Please remove the 4 screws of the back side and then remove the panel.

Make sure that the batteries are fitting tight at their place.

On the PC board you can see a little blue LED.

Now press at the same time the volume up and down button together, untill the LED flashes, then stop doing so.

If it flashes 1 time, the remote is for the CONDUCTOR

2 times for the EKLIPSE

and 3 times for the ASSISTENT 50 / 100.

You can change the program of the remote by pressing the buttons of the volume, untill the LED is flashing as much as you need to be the correct program.

Last update: 2008-09-30 10:18
Author: H.Becker
Revision: 1.0

Print this record Print this record
Send to a friend Send to a friend
Show this as PDF file Show this as PDF file
Export as XML-File Export as XML-File

Please rate this entry:

Average rating: 5 out of 5 (3 Votes )

completely useless 1 2 3 4 5 most valuable

You cannot comment on this entry