ECLIPSE

ID #1020

The active loudspeakers for which I have information are to be connected through standard, symmetrical XLR connectors. Will the so-called “fake” XLR output available on the Eklipse work with any symmetrical XLR on an amplifier or active loudspeakers, as far as wiring is concerned? For example I have read in the documentation of one of these active loudspeakers that \\"If your signal is unbalanced it is usual to connect the unused signal pin (i.e. pin 3) to ground. This is normally done inside the connecting cable\\" or \\"If connecting an unbalanced output to the balanced input make sure the shield is connected to the unbalanced ground of the source and to pins 1 and 3 of the XLR\\". Is it so with the “fake” XLR output on the Eklipse? Would I need a special XLR cable or will a standard XLR-XLR cable work?

The Eklipse has a fake XLR output. Pin 2 is the “hot wire” (positive), while Pins 1 (gnd) and 3 (neg. phase) are internally grounded. No special XLR cables are necessary. Your active speaker should have a volume control for optimum gain adaptation between Eklipse and your active speakers.

Last update: 2004-02-24 14:34
Author: Helmut
Revision: 1.0

Print this record Print this record
Send to a friend Send to a friend
Show this as PDF file Show this as PDF file
Export as XML-File Export as XML-File

Please rate this entry:

Average rating: 5 out of 5 (1 Votes )

completely useless 1 2 3 4 5 most valuable

You can comment on this entry

Comment of JimmiNil (2017-11-28 14:05:56):
f3zB1p http://www.LnAJ7K8QSpfMO2wQ8gO.com