AVALON

ID #1042

Hello I see the Avalon amps have two pairs of speaker outputs 4 + 8 ohms is it possible to use two cables runs from these outputs for bi wiring my speakers? Thanks

sure, your can use both pairs of speaker terminals to the same time for bi - wire.

The impedance will be go lower, but that is not a prob for the amp, they is powerfull enought to do this job.

The only problem is, that the 8 ohm terminals deliver more voltage then the 4 ohms. So you must test, witch speaker need witch terminals for good power output balance with the different speakers.

Last update: 2007-02-15 19:43
Author: Helmut
Revision: 1.0

Print this record Print this record
Send to a friend Send to a friend
Show this as PDF file Show this as PDF file
Export as XML-File Export as XML-File

Please rate this entry:

Average rating: 5 out of 5 (1 Votes )

completely useless 1 2 3 4 5 most valuable

You can comment on this entry